Nortel Networks BSG12aw Manual De Usuario
WiFi module replacement 61
Installation
Procedure steps
Step
Action
1
Unscrew and remove the two antennas.
2
Use a Phillips screwdriver to remove the screws on either side of the WiFi
module. You will feel the screws disengage when you have sufficiently loosened
them.
module. You will feel the screws disengage when you have sufficiently loosened
them.
3
Gently remove the WiFi module from the faceplate.
4
Slide the BSG12ew/aw/tw
WiFi Replacement Module (NT5S21ZAE6) into the
WiFi module slot.
5
Use a Phillips screwdriver to retighten the screws on either side of the WiFi
module. Do not overtighten the screws.
module. Do not overtighten the screws.
6
Screw the two antennas back onto the unit.
7
Power up the BSG12ew/aw/tw unit.
End
Verifying the WiFi installation
Use this procedure to verify the installation of the WiFi module in the BSG12ew/aw/tw.
Procedure steps
Step
Action
1
Launch an SSH session.
2
Log on to the BSG12ew/aw/tw using the user ID and password.
3
At the prompt, enter the following command:
show sub-system information wifi
4
Verify the status.
The system displays the following status if you installed the unit properly:
WiFi Info:
IpAddress: 169.254.1.3
OperStatus: UP
Firmware Version: <firmware version>
The system displays the following status if you did not install the unit properly:
WiFi Info:
IpAddress: 169.254.1.3
OperStatus: DOWN
Firmware Version: <firmware version>
5
Verify that your wireless-capable PC or laptop can connect with the broadcast
SSID and enable network connectivity.
SSID and enable network connectivity.