Nortel Networks BSG12aw ユーザーズマニュアル

WiFi module replacement 61

Installation

Unscrew and remove the two antennas.

Use a Phillips screwdriver to remove the screws on either side of the WiFi 
module. You will feel the screws disengage when you have sufficiently loosened 
them.

Gently remove the WiFi module from the faceplate.

Slide the BSG12ew/aw/tw

 

WiFi Replacement Module (NT5S21ZAE6) into the 

WiFi module slot.

Use a Phillips screwdriver to retighten the screws on either side of the WiFi 
module. Do not overtighten the screws.

Screw the two antennas back onto the unit.

Power up the BSG12ew/aw/tw unit.

Use this procedure to verify the installation of the WiFi module in the BSG12ew/aw/tw. 

Launch an SSH session.

Log on to the BSG12ew/aw/tw using the user ID and password.

At the prompt, enter the following command:

show sub-system information wifi

Verify the status.

The system displays the following status if you installed the unit properly:

The system displays the following status if you did not install the unit properly:

Verify that your wireless-capable PC or laptop can connect with the broadcast 
SSID and enable network connectivity.