Gateway E-826R Manual De Usuario
Chapter 2: Installing and Setting Up your Autoloader
www.gateway.com
16
Installation in a .375 square-hole rack
To install the rail in a .375 square-hole rack:
1
Identify the correct mounting holes on the vertical rail, making sure that
the selected holes are on the same level as the mounting holes on the
other three vertical rails.
the selected holes are on the same level as the mounting holes on the
other three vertical rails.
2
Mount the front cover plate to the vertical rail in the identified holes by
using 10-32 x .625 bolts in the center two holes of the plate.
using 10-32 x .625 bolts in the center two holes of the plate.
3
Install the chassis into the rack by aligning the chassis-mounted rails with
the mounted rail assemblies, then pushing the chassis into the rack.
the mounted rail assemblies, then pushing the chassis into the rack.
4
Secure the chassis into the rack by bolting the autoloader tabs to the
upper and lower holes in the front cover plate using 10-32 x .625 bolts.
upper and lower holes in the front cover plate using 10-32 x .625 bolts.
Front cover
plate
plate
10-32 inside
nut plate
nut plate
Rail
assembly
assembly
Vertical rail
Autoloader tab
(autoloader not
shown)
(autoloader not
shown)