Linksys WET11 Manual De Usuario

8

Chapter 4: Connecting the Wireless-B Ethernet Bridge for 
Setup

1. Attach the Bridge’s antenna.

2. Plug the included Ethernet network cable into the LAN port on the back panel of the Bridge, shown in Figure 

4-1.

3. The X-II (MDI/MDI-X) slide switch offers a choice between two settings. Slide the X-II switch to the X position 

if you are connecting the Bridge to a PC’s network adapter. Slide the X-II selection switch to the II position if 
you are connecting the Bridge to a hub or switch.

4. Plug the other end of the Ethernet network cable into the RJ-45 port of the hub, switch, or PC you wish to use 

to configure the Bridge.

5. Plug the supplied power adapter into the Power port on the back panel of the Bridge, shown in Figure 4-2. 

Then plug the other end into an electrical outlet.