Linksys WET11 Manual De Usuario

10

4. The screen shown in Figure 5-3 displays a list of Wireless-B Ethernet Bridges on your network, along with the 

status information for each Bridge. (If you have only one Bridge on your network, it will be the only one 
displayed.) Select the Bridge you are currently installing by clicking its name in the Selection box. Write down 
the IP address of the Wireless-B Ethernet Bridge, so you can use it to access the Web-based Utility later. Then 
click the Yes button. 

5. For security purposes, you will be asked for your password in order to access the Bridge, as shown in Figure 

5-4. In lowercase letters, enter admin in the Password field (later you can change the password through the 
Web-based Utility). Then click the Enter button.

6. The screen shown in Figure 5-5 shows a choice of two wireless modes. Click the Infrastructure radio button 

if you want your wireless computers to network with computers on your wired network using a wireless 
access point. Click the Ad-Hoc radio button if you want multiple wireless computers to network directly with 
each other. Do not use the Ad-Hoc mode if you want to network your wireless computers with computers on 
your wired network. 

In the WB Name field, enter a unique name for the Bridge. Memorable names are helpful, especially if you are 
using multiple bridges on the same network. Click the Next button to continue or the Back button to return to 
the previous screen.