Linksys WPS54GU2 Manual De Usuario

18

Chapter 6: Configuring the PrintServer Using the 
Web-based Utility

After setting up the PrintServer with the Setup Wizard, the PrintServer will be ready for use. However, if you’d like 
to change its advanced settings, use the PrintServer’s web-based utility. This chapter will describe each web 
page of the utility and each page’s key functions. The utility can be accessed via your web browser through the 
use of a networked computer.

There are six main tabs: Setup, Protocol, Wireless, Printer, Status, and Exit. Additional tabs will be available after 
you click one of the main tabs.

To access the web-based utility, launch Internet Explorer or Netscape Navigator, and enter the PrintServer’s IP 
address in the Address field. Then press Enter.

You will be asked to enter a User name and Password (see Figure 6-1). Leave the User name field blank, and 
enter admin in the Password field. Then click the OK button.

The first screen that appears is the Setup tab and allows you to change the PrintServer’s general settings.

Device Name. Enter the PrintServer’s name in the field provided. The name is located on a sticker on the bottom 
of the PrintServer.

Password. To change the PrintServer’s password, enter the current password in the Current Password field. 
Enter the new password in the New Password field, and then enter the new password again in the Verify 
Password field.

Protocols. Check the box(es) for AppleTalk or NetBEUI, if they are used by your network. 

Click the Save button to apply your changes, or click Cancel to cancel your changes.

NOTE: Use the PrintServer’s IP address that you noted when you ran the Setup Wizard. Otherwise, 
insert the Setup CD-ROM, and when the Welcome screen appears, click Setup Wizard. Follow the 
instructions until you reach the Wireless-G PrintServer Setup screen. Note the IP address, and then 
click Back until you reach the Welcome screen. Click Exit.