Linksys WPS54GU2 Manual De Usuario

19

Click the TCP/IP tab to view or change the TCP/IP values of the PrintServer. (See Figure 6-3.) 

IP Address. If your network router is using DHCP to assign IP addresses, select Obtain an IP Address 
Automatically. By default, Obtain an IP Address Automatically is enabled. If you need to assign the 
PrintServer a fixed IP address (also known as static IP address), select Use the Following IP Address, and enter 
the appropriate values under IP Address, Subnet Mask, and Gateway. Make sure the IP Address and Subnet Mask 
are appropriate for your network. If you change the PrintServer’s IP address, make sure you that you reconnect to 
the PrintServer using that new IP address. Otherwise, you will not be communicating with the PrintServer. In 
most cases, the Gateway IP address is the IP address of your router, and you should complete the Gateway field 
if you will use the PrintServer for Internet printing. (To find out your router’s IP address, consult your router’s 
documentation.) 

Connection. You can set how long you want the PrintServer to wait between connection attempts. You can also 
specify the number of times that the PrintServer will attempt to connect to the network. Enter your chosen values 
in the fields provided. 

Click the Save button to apply your changes, or click Cancel to cancel your changes.

AppleTalk is a network communications protocol that allows computers to talk to each other using Ethernet. 
Typically only Macintoshes use AppleTalk, although other platforms can use it if they have the necessary, third-
party software. (See Figure 6-4.) 

Communication. Port 1 is the parallel port, while Port 2 is the USB port.The PrintServer’s two ports have the 
same settings to configure for AppleTalk.

The Printer Object Type can be obtained from the manufacturer of the printer. Enter the type of printer in the field 
provided. For each printer connected to the PrintServer, you will choose the Communications Protocol that allows 
the devices on the network to communicate. Select the type of Communication Protocol you will use, ASCII or 
Binary for each printer, according to the recommendation of the printer’s manufacturer. For more information, 
refer to the printer’s documentation.

Click the Save button to apply your changes, or click Cancel to cancel your changes.