Linksys FENSK05 Manual De Usuario

Novell NetWare Setup

The instructions below cover the following versions of  
Novell NetWare: 

· NetWare workstations for DOS & Windows 3.x 
· Client32 for Windows 95 & Windows 98
· 3.12, 4.x, and 5.0 NetWare Servers 

If you have a version or type of NetWare not shown
above, run the README program on the EtherFast
Card disk to obtain the installation instructions for your
version. See page 10 for more information about the
README. 

The installation of the EtherFast Card's Novell worksta-
tion drivers is accomplished with a program on the
EtherFast Card disk called DIAG. DIAG will copy the
appropriate network drivers to your computer, generate
a NetWare NET.CFG file, and automatically update
your AUTOEXEC.BAT and CONFIG.SYS system files. 

DIAG also comes with a built-in diagnostic feature that
allows you to test the EtherFast Card's functionality at
any time. For more instructions on testing the card, see
the Troubleshooting section at the end of this guide.

1. Start up your computer in DOS. Insert the EtherFast
Card disk into drive A.

2. From the DOS command prompt (C:\>), type the fol-
lowing commands one-by-one. Press the Enter key
after each command:

NetWare