Delta Electronics DVPEN01-SL Manual De Usuario
Ethernet Communication Module DVPEN01-SL
DVP-PLC Application Manual
1
Warning
3
Please read this instruction carefully before use and follow this instruction to operate the device in order to prevent
damages on the device or injuries to staff.
3
Switch off the power before wiring.
3
RTU-DNET is an OPEN TYPE device and therefore should be installed in an enclosure free of airborne dust,
humidity, electric shock and vibration. The enclosure should prevent non-maintenance staff from operating the
device (e.g. key or specific tools are required for operating the enclosure) in case danger and damage on the
device may occur.
3
RTU-DNET is to be used for controlling the operating machine and equipment. In order not to damage it, only
qualified professional staff familiar with the structure and operation of RTU-DNET can install, operate, wire and
maintain it.
3
DO NOT connect input AC power supply to any of the I/O terminals; otherwise serious damage may occur. Check
all the wirings again before switching on the power and DO NOT touch any terminal when the power is switched
on. Make sure the ground terminal
is correctly grounded in order to prevent electromagnetic interference.
Table of Contents
1
INTRODUCTION...................................................................................................................................3
1.1
Functions.....................................................................................................................................3
1.2
Specifications ..............................................................................................................................3
2
PRODUCT PROFILE & OUTLINE .......................................................................................................4
2.1
Dimension ...................................................................................................................................4
2.2
Product Profiles...........................................................................................................................4
2.3
LED Indicators.............................................................................................................................5
2.4
RJ-45 PIN Definition....................................................................................................................5
3
INSTALLATION & WIRING ..................................................................................................................5
3.1
Installation ...................................................................................................................................5
4
CONTROL REGISTER (CR) ................................................................................................................6
4.1
Control Registers in DVPEN01-SL..............................................................................................6
4.2
Explanations on CR ....................................................................................................................8
4.3
Numbering of Left-Side Extension Modules ..............................................................................12
5
SETTING UP SOFTWARE .................................................................................................................13
5.1
Setting up Communication & Searching for Modules................................................................13
5.2
Basic Settings ...........................................................................................................................16
5.3
Network Settings .......................................................................................................................18
5.4
Setting up E-Mails .....................................................................................................................20
5.5
Data Exchange..........................................................................................................................22