RAD Data comm RIC-155 Manual De Usuario
RIC-155 Installation and Operation Manual
Chapter 4 Configuration
Additional Tasks
4-21
4. From the TFTP Command menu, (see
) select Download User File
to start downloading file to RIC-155.
RIC-155 automatically erases the backup partition and downloads the new
software into the backup partition. Once the download is complete,
RIC-155 performs a check and displays the Ended OK message. Then the
unit resets and loads the new software to the active partition; the old active
software is swapped into the backup partition.
software into the backup partition. Once the download is complete,
RIC-155 performs a check and displays the Ended OK message. Then the
unit resets and loads the new software to the active partition; the old active
software is swapped into the backup partition.
RIC-155
TFTP Command
1. No Operation
2. Download User File
3. Upload User File
4. Download Configuration
5. Upload Configuration
Please select item <1 to 5>
1. No Operation
2. Download User File
3. Upload User File
4. Download Configuration
5. Upload Configuration
Please select item <1 to 5>
ESC - prev. menu ; ! – main menu ; & – exit
Figure 4-23. TFTP Command
Installing a New Software Release via XMODEM
Installation of the new software releases via XMODEM is possible only via terminal
connection.
To install a new software release via XMODEM:
1. Follow the path: Main menu> File Utilities > SW & File Transfer > Via
1. Follow the path: Main menu> File Utilities > SW & File Transfer > Via
XMODEM
RIC-155 responds with the following string:
PLEASE OPEN XMODEM APPLICATION.
For exit press Q(uit)
If you press <Q>, RIC-155 aborts the download process and displays
Download failure. Press Esc to continue. in addition to the
previous display.
For exit press Q(uit)
If you press <Q>, RIC-155 aborts the download process and displays
Download failure. Press Esc to continue. in addition to the
previous display.
2. Send the *.img file to RIC-155 using the XMODEM protocol of your terminal
application.
Once the download is complete, RIC-155 displays the following message:
Final process download. Reset
After the decompression, RIC-155 is automatically reset. This causes the
new software to be loaded into the RIC-155.
new software to be loaded into the RIC-155.
To minimize the software downloading time, it is recommended to configure the
CONTROL port to the highest available data rate, see
CONTROL port to the highest available data rate, see
section above.
Note