Renesas 4513 Manual De Usuario
APPLICATION
2.2 Interrupts
2-13
4513/4514 Group User’s Manual
(7)
A-D interrupt
The interrupt request occurs by the end of the A-D conversion.
The interrupt request occurs by the end of the A-D conversion.
■
A-D interrupt processing
●
When the interrupt is used
The interrupt occurrence is enabled when the bit 2 of the interrupt control register V2 and the
interrupt enable flag INTE are set to “1.” When the A-D interrupt occurs, the interrupt processing
is executed from address C in page 1.
interrupt enable flag INTE are set to “1.” When the A-D interrupt occurs, the interrupt processing
is executed from address C in page 1.
●
When the interrupt is not used
The interrupt is disabled and the SNZAD instruction is valid when the bit 2 of register V2 is set
to “0.”
to “0.”
(8)
Serial I/O interrupt
The interrupt request occurs by the end of the serial I/O transmit/receive.
The interrupt request occurs by the end of the serial I/O transmit/receive.
■
Serial I/O interrupt processing
●
When the interrupt is used
The interrupt occurrence is enabled when the bit 3 of the interrupt control register V2 and the
interrupt enable flag INTE are set to “1.” When the serial I/O interrupt occurs, the interrupt
processing is executed from address E in page 1.
interrupt enable flag INTE are set to “1.” When the serial I/O interrupt occurs, the interrupt
processing is executed from address E in page 1.
●
When the interrupt is not used
The interrupt is disabled and the SNZSI instruction is valid when the bit 3 of register V2 is set
to “0.”
to “0.”
2.2.2 Related registers
(1)
Interrupt enable flag (INTE)
The interrupt enable flag (INTE) controls whether the every interrupt enable/disable.
Interrupts are enabled when INTE flag is set to “1” with the EI instruction and disabled when INTE
flag is cleared to “0” with the DI instruction.
When any interrupt occurs, the INTE flag is automatically cleared to “0,” so that other interrupts are
disabled until the EI instruction is executed.
The interrupt enable flag (INTE) controls whether the every interrupt enable/disable.
Interrupts are enabled when INTE flag is set to “1” with the EI instruction and disabled when INTE
flag is cleared to “0” with the DI instruction.
When any interrupt occurs, the INTE flag is automatically cleared to “0,” so that other interrupts are
disabled until the EI instruction is executed.
Note: The interrupt enabled with the EI instruction is performed after the EI instruction and one more
instruction.