Renesas M16C/64 Manual De Usuario

R0E530640MCU00 User’s Manual 

5. Debugging Functions 

REJ10J1733-0100  Rev.1.00  Apr. 01, 2008 
Page 128 of 229 

 

 

 
 
(3) Other conditions 

You can select one of five choices available: AND (Accumulation), AND (Simultaneous), Subroutine, Sequential and State 
Transition. To set any condition, select the check box to the left of “Other Conditions.” 
By default, other conditions are disabled (the check box to the left of “Other Conditions” is unselected). 
 

 

Figure 5.52 Trace conditions dialog box 
 
 
Table 5.21 Other conditions 
 Type 

Description 

1 

AND (Accumulation) 

Trace point is encountered when all of the set events occur irrespective of the time axis. 

2 

AND (Simultaneous) 

Trace point is encountered when all of the set events occur at the same time. 

3 

Subroutine 

Trace point is encountered when a specified event occurs within a specified address range 
(subroutine or function). 

4 

Sequential 

6 steps (forward direction) + reset point 
Trace point is encountered when a set event occurs in a specified order. 

5 

State transitions 

3 steps, 9 paths + reset point 
Trace point is encountered when a set event occurs in a specified order.