Cisco Systems 7500 Series Manual De Usuario

This completes the procedure for attaching DC-input cables to the Cisco 7505 DC-input power supply, 
as well as procedures required to install the Cisco 7505.

For information on how to connect cables to the RSP, see the 

, and then proceed to the 

.

This section provides procedures for installing your Cisco 7507 and Cisco 7507-MX and for connecting 
power cables to power supplies. 

 illustrates the order of procedures to install the Cisco 7507 

or Cisco 7507-MX router and connect cables. It also indicates the Cisco publications you should refer 
to for more detailed information. 

Depending on your configuration, you might need to insert additional or new processor modules in your 
Cisco 7507 or Cisco 7507-MX. To insert or remove interface processors, you do not need to turn off 
power to the system. However, if the system is operating, you must turn off the system power before you 
insert or remove an RSP2, RSP4, or RSP8. 

You need a number 1 Phillips or 3/16-inch flat-blade screwdriver to remove any fillers (blank processor 
module carriers) and to tighten the captive installation screws that secure the processor module in its slot. 
Whenever you handle modules, you should use an ESD-preventive wrist strap or other grounding device 
to prevent ESD damage. 

Make external connections

H9718

Perform an initial configuration and

create a basic configuration file. Use the

procedures in Chapter 4 “Performing

a Basic Configuration of the System.”

For more information about configuration,

refer to the Cisco IOS configuration

guides and command references.

Insert power supplies

Unpack the router

(Use Cisco 7000 and Cisco 7507

Rack-mount the router

(Use Cisco 7000 and Cisco 7507