Cisco Systems RV130W Manual De Usuario

Configuring IPv6

Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide

50

 

You can configure static routes to direct packets to the destination network. A 
static route is a predetermined pathway that a packet must travel to reach a 
specific host or network. 

Some ISPs require static routes to build a routing table instead of using dynamic 
routing protocols. Static routes do not require CPU resources to exchange routing 
information with a peer router. 

You can also use static routes to reach peer routers that do not support dynamic 
routing protocols. Static routes can be used together with dynamic routes. Be 
careful not to introduce routing loops in your network.

To create a static route:

Choose Networking > IPv6 > IPv6 Static Routing.

In the list of static routes, click Add Row.

Enter this information:

Route name.

 IPv6 address of the destination host or network for 
this route.

Number of prefix bits in the IPv6 address that define 
the destination subnet.

IPv6 address of the gateway through which the 
destination host or network can be reached.

Interface for the route: LAN, WAN, or 6to4.

Priority of the route. Choose a value between 2 and 15. 
If multiple routes to the same destination exist, the 
route with the lowest metric is used.

Check to make the route active. When you add a route 
in an inactive state, it is listed in the routing table, but is 
not used by the device. 

Entering an inactive route is useful if the route is not 
available when you add the route. When the network 
becomes available, you can enable the route.