Cisco Systems RV130W Manual De Usuario
Configuring Networking
Configuring IPv6
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide
51
3
STEP 4
Click Save.
To edit the settings of a route, select the route and click Edit. To delete a selected
route, click Delete. Click Save to apply changes.
route, click Delete. Click Save to apply changes.
Configuring Routing (RIPng)
RIP Next Generation (RIPng) is a routing protocol based on the distance vector
(D-V) algorithm. RIPng uses UDP packets to exchange routing information through
port 521.
(D-V) algorithm. RIPng uses UDP packets to exchange routing information through
port 521.
RIPng uses a hop count to measure the distance to a destination. The hop count is
referred to as metric, or cost. The hop count from a router to a directly connected
network is 0. The hop count between two directly connected routers is 1. When
the hop count is greater than or equal to 16, the destination network or host is
unreachable.
referred to as metric, or cost. The hop count from a router to a directly connected
network is 0. The hop count between two directly connected routers is 1. When
the hop count is greater than or equal to 16, the destination network or host is
unreachable.
By default, the routing update is sent every 30 seconds. If the router receives no
routing updates from a neighbor after 180 seconds, the routes learned from the
neighbor are considered as unreachable. After another 240 seconds, if no routing
update is received, the router removes these routes from the routing table.
routing updates from a neighbor after 180 seconds, the routes learned from the
neighbor are considered as unreachable. After another 240 seconds, if no routing
update is received, the router removes these routes from the routing table.
On your device, RIPng is disabled by default.
To configure RIPng:
STEP 1
Choose Networking > IPv6 > Routing (RIPng).
STEP 2
Check Enable.
STEP 3
Click Save.