Cisco Systems UBR924 Manual De Usuario
4-11
Cisco uBR924 Software Configuration Guide
OL-0337-05 (8/2002)
Chapter 4
Voice over IP Configurations
H.323v2 Dynamic Mapping Configuration
destination-pattern 6101
session target ipv4:24.1.61.5
!
dial-peer voice 103 voip
destination-pattern 6102
session target ipv4:24.1.61.5
dtmf-relay cisco-rtp
!
!
interface Ethernet0
ip address 24.1.61.1 255.255.255.0
no ip directed-broadcast
no ip mroute-cache
!
interface cable-modem0
ip address dhcp
no ip directed-broadcast
no ip mroute-cache
cable-modem downstream saved channel 537000000 27
no cable-modem compliant bridge
!
router rip
version 2
network 10.0.0.0
network 24.0.0.0
no auto-summary
!
no ip classless
ip route 0.0.0.0 0.0.0.0 10.1.71.1
no ip http server
no service finger
!
!
line con 0
exec-timeout 0 0
transport input none
line vty 0 4
login
!
!
end
Note
The above configuration assumes that the DHCP server assigns an IP address to the cable interface that
is in the class A private network (10.0.0.0).
is in the class A private network (10.0.0.0).
H.323v2 Dynamic Mapping Configuration
When using a Cisco IOS image that supports voice, the Cisco uBR924 router supports using the
Registration, Admission, and Status (RAS) protocol to allow a remote gatekeeper to translate phone
numbers (E.164 addresses) to the IP addresses of specific dial peers. This allows the gatekeeper to
maintain a central database of dial peers, so that this information does not have to be entered into static
dial maps on every router that is acting as a voice gateway.
Registration, Admission, and Status (RAS) protocol to allow a remote gatekeeper to translate phone
numbers (E.164 addresses) to the IP addresses of specific dial peers. This allows the gatekeeper to
maintain a central database of dial peers, so that this information does not have to be entered into static
dial maps on every router that is acting as a voice gateway.
Note
The Cisco uBR924 router can use H.323v2 dynamic mapping in either DOCSIS-bridging mode or
routing mode.
routing mode.