Cisco Systems TES301 Manual De Usuario
Chapter 3 Configuration and Operation of the TES301
36
4038767 Rev A
If yes, choose STUN or Port Mapping from the NAT Traversal Mode drop-
down menu; then, continue with the next step.
Note: Use the scroll bar to access all of the fields on this screen.
down menu; then, continue with the next step.
Note: Use the scroll bar to access all of the fields on this screen.
3 If you selected the STUN option, complete the following steps:
a STUN Server Address—Enter the address of a STUN server running on
public network. Your device will send a discover request to the STUN server
and decide NAT mode based on the response message from the STUN
server.
and decide NAT mode based on the response message from the STUN
server.
b STUN Server Port—Specify the port for the STUN server. Your device will
send a discover request to the STUN server via the specified port.
c NAT Keep Alive Interval—Enter the number of seconds to indicate the
interval for your device to send discover requests to keep NAT traversal
active.
active.
d Skip to step 5 to continue.
4 If you selected the Port Mapping option, complete the following steps:
a External Router Address—Enter the external router address.
b External SIP Signal Port—Enter the external SIP signal port used to
b External SIP Signal Port—Enter the external SIP signal port used to
communicate with SIP agent in public network.
c External Base RTP Port—Enter the external RTP stream port used to
communicate with SIP agent in public network.
5 Complete the following steps to configure Codec Settings:
a From the Disabled Codec list, select a Codec you want to enable.