Cisco Systems TES301 Manual De Usuario

 

4038767 Rev A 

37 

 

b  Click the Move Right arrow to move the selected item to the Enabled Codec 

list. 

c  Use the Up/Down buttons to prioritize the Enabled Codecs. 
d  Select the top Codec in the Enabled list. The Codec Properties fields become 

active. 

e  Complete the Codec Properties fields associated with the Codec selected: 

– 

Payload Type—This value is pre-populated with a default setting. The 
field will not be configurable if the default value is a required setting for 
the codec selected.  

– 

Name—Provide a name to identify the codec type. 

– 

Frame Size in ms—Select a setting to configure interval between sending 
RTP packets out to the RTP stream. 

– 

Bit Rate—Select the data transmission rate from the list of available 
options. 

f  DTMF Relay Method—Select one of the following methods by which DTMF 

digits will be passed during a voice call: 

– 

In Band—Select In Band mode to use the voice band when a key is 
pressed during a voice call. 

– 

Out of Band—Select Out of Band mode to use an independent band 
when a key is pressed during a voice call. If you select this option, the 
RFC2833 Payload Type field will appear for your to enter a value to 
configure the RFC 2833 payload decimal. 

– 

SIP Info—Select SIP Info if you want a key press to be sent remotely 
through SIP packets during a voice call.  

6  Click Save Changes to save the information or Cancel to return to the 

dashboard.