Cisco Systems CISCO7201 Manual De Usuario

After powering off the router, wait a minimum of 30 seconds before powering it on again.

If required, use Sinewave Output UPS (uninterruptable power supply), not Ferro-resonant type UPS.

This completes the procedure for connecting AC-input power. Your installation is complete. Proceed to 

 to start the router and to perform a basic configuration.

This section provides instructions for installing the DC power supply ground leads and installing the 
DC-input power leads.

The Cisco 7201 has two of the same type of power supplies in power supply slot 1 and power supply 

 

slot 2. See 

. The power supply slot numbers are on the chassis to the left of the left power 

supply, and to the right of the right power supply.

Never install an AC power module and a DC power module in the same chassis. Statement 1050

Before you connect DC-input power, you must install the DC power ground leads to the DC power 
supply.

When installing or replacing the unit, the ground connection must always be made first and 
disconnected last. Statement 1046

Power supply slot 1

Power supply slot 2

230086