Cisco Systems Cisco 815 Manual De Usuario
19
Note
Because Cisco SDM is installed on your router by default, we recommend using Cisco SDM to perform the
initial configuration.
initial configuration.
See the “Configure the Router Using Cisco Router and Security Device Manager” section on page 19 to learn how to
configure your router using Cisco SDM, or how to obtain Cisco SDM and install it on your router.
configure your router using Cisco SDM, or how to obtain Cisco SDM and install it on your router.
Note
If you do not have Cisco SDM on your router, and would like to use Cisco SDM, go to the following location
for instructions on how to install it on your Cisco 815 series router:
for instructions on how to install it on your Cisco 815 series router:
If you see the following messages, the router has booted and is ready for initial configuration using the setup command
facility or the command-line interface (CLI):
facility or the command-line interface (CLI):
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
To use the setup command facility and use the CLI to configure the router, see the
If the rommon 1> prompt appears, your system has booted in ROM monitor mode.
Verifying the Hardware Configuration
To display and verify the hardware features, enter the show version command. This command displays the system hardware
version; the installed software version; the names and sources of configuration files; the boot images; and the amount of installed
DRAM, NVRAM, and flash memory.
version; the installed software version; the names and sources of configuration files; the boot images; and the amount of installed
DRAM, NVRAM, and flash memory.
9
Perform Initial Configuration
This section provides the procedures for performing the initial configuration of your Cisco 815 integrated services router.
Configure the Router Using Cisco Router and Security Device Manager
Cisco Router and Security Device Manager (Cisco SDM) is a web-based configuration tool that allows you to configure LAN
and WAN interfaces, routing, Network Address Translation (NAT), firewalls, VPNs, and other features on your router. If Cisco
SDM is installed on your router, configure the router by following the instructions in the Cisco Router and Security Device
Manager Quick Start Guide. If this document was not shipped with your router, you can obtain Cisco SDM and instructions
for installing it on your router from the following location:
and WAN interfaces, routing, Network Address Translation (NAT), firewalls, VPNs, and other features on your router. If Cisco
SDM is installed on your router, configure the router by following the instructions in the Cisco Router and Security Device
Manager Quick Start Guide. If this document was not shipped with your router, you can obtain Cisco SDM and instructions
for installing it on your router from the following location:
Note
http://www.cisco.com/go/sdm
and
click the Technical Documentation link.