Cisco Systems IPMUX-1E Manual De Usuario
Appendix E Configuration Menus
IPmux-1/1E Installation and Operation Manual
E-12 General
Configuration
Table E-6. IPmux-1/1E Alarms
Alarm ID
Alarm Description
Trap Sent to NMS
1
Loss of Signal (LOS Physical Layer)
Alarm LOS
1.3.6.1.4.1.164.6.1.3.0.7
2
Loss of Frame (LOF Physical Layer)
Alarm LOF
1.3.6.1.4.1.164.6.1.3.0.8
6
Alarm Indication Signal Received (AIS
Line Physical Layer)
Alarm AIS
1.3.6.1.4.1.164.6.1.3.0.10
8
Remote Defect Indication Received (RDI
Line Physical Layer)
Alarm RDI
1.3.6.1.4.1.164.6.1.3.0.11
21
Far End Block Error (FEBE Line Layer)
Alarm FEBE
1.3.6.1.4.1.164.6.1.3.0.12
26
Connectivity Status
Conn Status Trap
1.3.6.1.4.1.164.6.1.3.0. 15
1.3.6.1.4.1.164.6.1.3.0. 15
The other alarms are not used.
Telnet Access
It is possible to manage the IPmux-1/1E inband via remote ASCII Terminal using
the Telnet IP protocol.
the Telnet IP protocol.
To configure Telnet Access:
• Select:
• Select:
Enable
–Telnet is enabled
Disable
– Telnet is disabled
Managers
– Telnet is enabled only when the Managers List contains the IP
and VLAN of the computer that opens the Telnet session (see
Appendix B
).
ASCII Terminal Configuration
ASCII TERMINAL CONFIGURATION
1. Display Mode Color
2. Baud Rate (bps) 19200
3. Change Password
4. 15 Min. Timeout On
ESC. Exit
NOTICE: Change the Baud Rate of the ASCII terminal after
changing and saving of new Baud Rate data !
Select item from the menu:_
Use <Esc> key or keys <1> to <4>
Figure E-16. ASCII Terminal Configuration Menu
Main Menu
↓
2. Configuration
↓
1. General
Configuration
Configuration
↓
3. ASCII
Terminal Config
Terminal Config
Note
Main Menu
↓
2. Configuration
↓
1. General
Configuration
Configuration
↓
2. Management
Configuration
Configuration
↓
4. Telnet Access