Cisco Systems Cisco 7204 Manual De Usuario
3-7
Cisco 7204 Installation and Configuration Guide
OL-5101-02
Chapter 3 Installing the Cisco 7204
Rack-Mounting the Cisco 7204
Step 3
If you aligned the first rack-mount bracket and cable-management bracket to the right side of the chassis,
thread two M4 x 8-mm Phillips flathead screws through both brackets and into the side of the chassis.
Use a number 2 Phillips screwdriver to tighten the screws. (Refer to
thread two M4 x 8-mm Phillips flathead screws through both brackets and into the side of the chassis.
Use a number 2 Phillips screwdriver to tighten the screws. (Refer to
If you aligned only the first rack-mount bracket to the right side of the chassis, thread two M4 x 8-mm
Phillips flathead screws through the bracket into the side of the chassis and use a number 2 Phillips
screwdriver to tighten the screws. Then align the first cable-management bracket to the rack-mount
bracket and thread two M4 x 8-mm Phillips flathead screws through the two brackets. Use a number 2
Phillips screwdriver to tighten the screws. (Refer to
Phillips flathead screws through the bracket into the side of the chassis and use a number 2 Phillips
screwdriver to tighten the screws. Then align the first cable-management bracket to the rack-mount
bracket and thread two M4 x 8-mm Phillips flathead screws through the two brackets. Use a number 2
Phillips screwdriver to tighten the screws. (Refer to
.)
Step 4
Repeat Step 1 through Step 3 for the other cable-management bracket (if required) and rack-mount
bracket.
bracket.
This completes the procedure for installing the rack-mount and cable-management brackets on a
Cisco 7204 for a front rack-mount configuration.
Cisco 7204 for a front rack-mount configuration.
Installing Brackets on the Rear of the Chassis
To install the rack-mount and cable-management brackets on a Cisco 7204 for a rear rack-mount
configuration, complete the following steps:
configuration, complete the following steps:
Step 1
Locate the threaded holes in the rear sides of the chassis.
Step 2
Align the first rack-mount bracket to the threaded holes in the right side of the chassis.
If you want the front of the chassis protruding out of the rack, align the rack-mount bracket to the chassis
as shown in
as shown in
. If you want the front of the chassis recessed in the rack, align the rack-mount
bracket to the chassis as shown in
.
Figure 3-8
Installing the Rack-Mount Brackets on the Rear of the Chassis so the Front
Protrudes Out of the Rack
Protrudes Out of the Rack
EN
A
B
LE
D
M
II
L
IN
K
R
J4
5
FAST ETHERNET
0
0
2
4
1
3
EN
0
7
1
2
3
4
5
6
SERIAL-EIA/TIA-232
ETHERNET-10BFL
EN
RX
0
1
2
3
4
TX
RX
TX
RX
TX
RX
TX
RX
TX
H9154
Cisco 7200
SERIES
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
R
J-
45
C
P
U
R
E
S
E
T
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
Rack-mount
bracket
bracket
Cable-management
bracket
bracket