Cisco Systems ASR 1000 Series Manual De Usuario

This is only an example of the output display; prompts may vary.

When you see this information, you have successfully booted your router:

Restricted Rights Legend

 

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

 

           cisco Systems, Inc.

           170 West Tasman Drive

San Jose, California 95134-1706

.

.

.

         --- System Configuration Dialog ---

 

Would you like to enter the initial configuration dialog? [yes/no]: yes

 

Press RETURN to get started!

The first sections of the configuration script appear only at an initial system startup. On subsequent uses 
of the setup facility, the script begins with a System Configuration Dialog as shown below: When asked 
if you would like to enter the initial configuration dialog, enter yes.

Would you like to enter the initial configuration dialog? [yes/no] yes

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity for management of the 

system, extended setup will ask you to configure each interface on the system.

Basic management setup configures enough connectivity for managing the system; extended setup will 
ask you to configure each interface on the system. For detailed information about setting global 
parameters, refer to the Cisco ASR 1000_Series Aggregation Services Routers Software Configuration 
Guide.

To check the value of the settings you have entered, enter the show running-config command at the

 

Router#

 prompt:

Router# show running-config