Cisco Systems OL-7426-03 Manual De Usuario

Configuring Mobility Groups

All Cisco Wireless LAN Controllers that can communicate with each other through their Distribution 
System (network) ports can automatically discover each other and form themselves into groups. After 
they are grouped, the Cisco WLAN Solution Radio Resource Management (RRM) function maximizes its 
inter-Cisco Wireless LAN Controller processing efficiency and mobility processing, described in the 

 section.

Cisco Wireless LAN Controller group discovery is automatically enabled when two or more members are 
assigned to the same mobility group name. Note that this feature must be enabled on each Cisco 
Wireless LAN Controller to be included in the discovery process.

•

Use the show mobility summary command to verify the current Cisco Wireless LAN Controller 
mobility settings.

•

To give a Mobility Group a name, use the following command:

>config mobility group name <group_name>

where <group_name> = Any ASCII character string, up to 31 characters, case sensitive, with 
no spaces. 

•

To manually add or delete members to a mobility group, use the following commands:

>config mobility group member add <mac-address> <IP addr>
>config mobility group member delete <mac-address> <IP addr>

where <mac-address> is the MAC address and where <IP addr> is the IP Address of the group 
member to be added or deleted.

Use the show mobility summary commands to verify that the Cisco Wireless LAN Controller mobility is 
set up correctly. Continue with 

.

Configuring RADIUS

•

When your Cisco WLAN Solution is to use an external RADIUS server for accounting and/or 
authentication, set up the links using the following commands. If you are not configuring 
RADIUS links at this time, continue with 

>config radius acct <address> 
>config radius acct <port>
>config radius acct <secret>
>config radius acct [disable/enable]
>config radius auth <address> 
>config radius auth <port>
>config radius auth <secret>
>config radius auth [disable/enable]

where <address> = server name or IP Address, <port> = UDP port number, <secret> = the 
RADIUS server's secret.

When you have completed these configurations, use the show radius acct statistics, show 
radius auth statistics 

and show radius summary commands to verify that the RADIUS links are 

correctly configured. Continue with