Cisco Systems OL-7426-03 Manual De Usuario

TFTP receive complete... extracting components.

Writing new bootloader to flash.

Making backup copy of RTOS.

Writing new RTOS to flash.

Making backup copy of Code.

Writing new Code to flash.

TFTP File transfer operation completed successfully.

Please restart the switch (reset system) for update to complete.

•

The Cisco Wireless LAN Controller now has the code update in active volatile RAM, but you must 
save the code update to non-volatile NVRAM and reboot the Cisco Wireless LAN Controller: 

>

The system has unsaved changes.

Would you like to save them now? (y/n) 

The Cisco Wireless LAN Controller completes the bootup process as described in the Performing 
Power On Self Test step in the appropriate Cisco Wireless LAN Controller Quick Start Guide. 

Refer to the 

 section for other file upload 

and download instructions.

Using the Startup Wizard

When a Cisco Wireless LAN Controller is powered up with a new factory Operating System software load 
or after being reset to factory defaults, the bootup script runs the Startup Wizard, which prompts the 
installer for initial Cisco Wireless LAN Controller configuration. 

Use the Startup Wizard to do the following:

•

Enter the System (Cisco Wireless LAN Controller) Name, up to 32 printable ASCII characters.

•

Enter the Administrative username and password, each up to 24 printable ASCII characters. 
The default Administrative User login and password are admin and admin, respectively.

•

 IP configuration protocol (none, or DHCP). If you do not want to 

use the Service port or if you want to assign a static IP Address to the Service port, enter none.
If you entered none, enter 

 IP Address and netmask on the next two 

lines. If you do not want to use the Service port, enter 0.0.0.0 for the IP Address and 
netmask.

•

 IP Address, netmask, default router IP address, and optional 

VLAN identifier (a valid VLAN identifier, or ‘0’ for untagged).

 If you wish to run a previous release of the Cisco Wireless LAN Controller code, 

follow the instructions in the Connecting and Using the CLI Console step in the 
appropriate Cisco Wireless LAN Controller Quick Start Guide. 

 To reset the Cisco Wireless LAN Controller to factory defaults and rerun the 

Startup Wizard, refer to 

 The 

 must be on different 

subnets.