Cisco Systems OL-7426-03 Manual De Usuario
5/26/05
Adding SSL to the Web User Interface
OL-7426-03
•
Network Interface (Distribution System) Physical Port number:
* Cisco 2000 Series Wireless LAN Controllers: 1 through 4 for a back panel Ethernet port
* Cisco 4100 Series Wireless LAN Controllers: 1 or 2 for a front panel GigE port
* Cisco 4400 Series Wireless LAN Controllers: 1 through 4 for a front panel GigE port
* Cisco 2000 Series Wireless LAN Controllers: 1 through 4 for a back panel Ethernet port
* Cisco 4100 Series Wireless LAN Controllers: 1 or 2 for a front panel GigE port
* Cisco 4400 Series Wireless LAN Controllers: 1 through 4 for a front panel GigE port
•
Enter the IP address of the default DHCP Server that will supply IP Addresses to clients, the
Cisco Wireless LAN Controller Management Interface, and optionally to the Service Port
Interface.
Cisco Wireless LAN Controller Management Interface, and optionally to the Service Port
Interface.
•
Enter the LWAPP Transport Mode, LAYER2 or LAYER3 (refer to
).
•
Enter the Virtual Gateway IP Address; any fictitious, unassigned IP address (such as 1.1.1.1) to
be used by Layer 3 Security and Mobility managers.
be used by Layer 3 Security and Mobility managers.
•
(RF Group) Name.
•
Enter the WLAN 1 SSID, or Network Name. This is the default SSID that the Cisco 1000 Series
lightweight access points broadcast when they associate with the Cisco Wireless LAN Controller.
lightweight access points broadcast when they associate with the Cisco Wireless LAN Controller.
•
Allow or disallow Static IP Addresses for clients. (Yes = clients can supply their own IP Address.
No = clients must request an IP Address from a DHCP server.)
No = clients must request an IP Address from a DHCP server.)
•
If you are configuring a RADIUS Server now, enter YES, and the RADIUS Server IP Address,
communication port, and Secret. Otherwise, enter NO.
communication port, and Secret. Otherwise, enter NO.
•
Enter the Country Code for this installation. Type ‘help’ to list the supported countries, and refer
to
to
•
Independently enable and/or disable the 802.11b, 802.11a, and 802.11g Cisco 1000 Series
lightweight access point networks.
lightweight access point networks.
•
Enable or disable the
The Cisco Wireless LAN Controller saves your configuration, reboots with your changes, and
prompts you to log in or enter ‘Recover-Config’ to reset the Cisco Wireless LAN Controller to
factory default configuration and return to the Startup Wizard.
prompts you to log in or enter ‘Recover-Config’ to reset the Cisco Wireless LAN Controller to
factory default configuration and return to the Startup Wizard.
Continue with
.
Adding SSL to the Web User Interface
Adding SSL to the Web User Interface
When you plan to secure the Cisco Wireless LAN Controller HTTP: Web User Interface using the https:
(HTTP + SSL) protocol, note that the Operating System automatically generates its own local Web
Administration SSL certificate and automatically applies it to the Web User Interface. Verify whether or
not the locally-generated Web Administration certificate is already loaded:
(HTTP + SSL) protocol, note that the Operating System automatically generates its own local Web
Administration SSL certificate and automatically applies it to the Web User Interface. Verify whether or
not the locally-generated Web Administration certificate is already loaded:
>
show certificate summary
Web Administration Certificate................. Locally Generated
Web Authentication Certificate................. Locally Generated
Certificate compatibility mode:................ off
Continue with either of the following two sections:
•
or an
•
.