Cisco Systems 1900 Series Manual De Usuario

Connect each WAN and LAN cable to the appropriate connector on the chassis or interface card.

Position the cables carefully, so that they do not put strain on the connectors.

Organize the cables in bundles so that cables do not intertwine.

Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition the 
cables, if necessary.

Install cable ties in accordance with your site requirements.

For cable pinouts, refer to 

.

Your router has asynchronous serial, USB, console, and auxiliary ports. These ports provide 
administrative access to your router either locally (with a console terminal or PC) or remotely (with a 
modem).

The following cables and adapters may be used for connecting your router to a console terminal, PC, or 
modem:

USB console cable—USB 5-pin mini Type-B to USB Type-A. See the 

 for port details and the 

Console cable— EIA RJ-45 to DB-9

Modem adapter—DB-9 to DB-25

The first time a Windows-based PC is connected to the router, a USB device driver must be installed. 
See the 

.

This section describes how to connect a console terminal or PC to the console port and how to connect 
a modem to the auxiliary port.

To configure the router through the Cisco IOS command-line interface (CLI), you must connect the 
router console port to a terminal or PC. See the 

.

A Microsoft Windows PC must have HyperTerminal or similar terminal emulation software installed. 
The software should be configured with the following parameters: 9600 baud, 8 data bits, no parity, 1 
stop bit, and no flow control. Refer to the Cisco 3900 Series, 2900 Series, and 1900 Series Software 
Configuration Guide for detailed information about using Cisco IOS software for configuring the router.