Cisco Systems 1900 Series Manual De Usuario
5-10
Cisco 1900 Series Hardware Installation
OL-19084-02
Chapter 5 Configuring the Router
Performing the Initial Configuration on the Router
DETAILED STEPS
Configuring the Console Idle Privileged EXEC Timeout
This section describes how to configure the console line’s idle privileged EXEC timeout. By default, the
privileged EXEC command interpreter waits 10 minutes to detect user input before timing out.
privileged EXEC command interpreter waits 10 minutes to detect user input before timing out.
When you configure the console line, you can also set communication parameters, specify autobaud
connections, and configure terminal operating parameters for the terminal that you are using. For more
information on configuring the console line, see the Cisco IOS Configuration Fundamentals and
Network Management Configuration Guide. In particular, see the “Configuring Operating
Characteristics for Terminals” and “Troubleshooting and Fault Management” chapters.
connections, and configure terminal operating parameters for the terminal that you are using. For more
information on configuring the console line, see the Cisco IOS Configuration Fundamentals and
Network Management Configuration Guide. In particular, see the “Configuring Operating
Characteristics for Terminals” and “Troubleshooting and Fault Management” chapters.
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure
terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
enable password
password
Example:
Router(config)# enable password pswd2
(Optional) Sets a local password to control access to various
privilege levels.
privilege levels.
•
We recommend that you perform this step only if you
boot an older image of the Cisco IOS software or if you
boot older boot ROMs that do not recognize the enable
secret command.
boot an older image of the Cisco IOS software or if you
boot older boot ROMs that do not recognize the enable
secret command.
Step 4
enable secret
password
Example:
Router(config)# enable secret greentree
Specifies an additional layer of security over the enable
password command.
password command.
•
Do not use the same password that you entered in
Step 5
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Step 6
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Verify that your new enable or enable secret password
works.
works.
Step 7
end
Example:
Router(config)# end
(Optional) Returns to privileged EXEC mode.