Cisco Systems 2600XM Series Manual De Usuario
17
Step 4
Secure the wires using cable ties.
Step 5
Turn on power to the DC circuit.
Connecting Routers to the Cisco Redundant Power System
If your router uses the Cisco Redundant Power System (RPS), refer to the Cisco RPS Hardware Installation Guide for
instructions about the power connections. To locate these documents, see the “Where to Go Next” section on page 24.
instructions about the power connections. To locate these documents, see the “Where to Go Next” section on page 24.
WAN, LAN, and Voice Connections
The connections and cables listed here are described in detail in the following documents:
Table 3 summarizes some typical WAN, LAN, and voice connections for Cisco 2600XM series and Cisco 2612 routers.
Table 3
WAN, LAN, and Voice Connections
Port or Connection
Port Type, Color
Connected To:
Cable
Ethernet
RJ-45, yellow
Ethernet hub or Ethernet switch
Straight-through Ethernet
T1/E1 WAN
RJ-48C/CA81A, blue
T1 or E1 network
RJ-48 T1
Cisco serial
60-pin D-sub
CSU/DSU and serial network or
equipment
equipment
Cisco serial transition cable that matches
the signaling protocol (EIA/TIA-232,
EIA/TIA-449, V.35, X.21, or EIA-530)
and the serial port operating mode (DTE
or DCE).
the signaling protocol (EIA/TIA-232,
EIA/TIA-449, V.35, X.21, or EIA-530)
and the serial port operating mode (DTE
or DCE).
1
1. See the Cisco Modular Access Router Cable Specifications document for information about selecting these cables.
Cisco Smart serial
Cisco Smart compact
connector, blue
connector, blue
CSU/DSU and serial network or
equipment (For WIC-2T and
WIC-2A/S only)
equipment (For WIC-2T and
WIC-2A/S only)
DSL
RJ-11C/CA11A,
lavender
lavender
Network demarcation device for
service provider’s DSL interface
service provider’s DSL interface
RJ-11
T1 digital voice
RJ-48C/CA81A, tan
Digital PBX
RJ-48 T1 cable
Analog voice FXS
RJ-11, gray
Telephone, fax
RJ-11
Analog voice FXO
RJ-11, pink
Central office, analog PBX
RJ-11
Analog voice E&M
RJ-11, brown
Analog PBX
RJ-11
BRI S/T WAN
(external NT1)
(external NT1)
RJ-48C/CA81A, orange NT1 device or private integrated
network exchange (PINX)
RJ-48
BRI U WAN
(built-in NT1)
(built-in NT1)
RJ-49C/CA-A11, red
ISDN network
RJ-49
CT1/PRI
T1
External T1 CSU
DB-15 T1 serial cable
CT1/PRI-CSU
T1
RJ-48C/CA81A interface
RJ-48 straight-through
CE1/PRI
E1
E1 network
DB-15 to BNC, DB-15 to DB-15,
DB-15 to twinax, or DB-15 to RJ-45
DB-15 to twinax, or DB-15 to RJ-45
Token Ring
UTP, purple
STP, purple
Token Ring device
RJ-45 Token Ring cable
56/64-kbps DSU/CSU 8-pin modular, blue
RJ-48S interface
RJ-48 straight-through