Cisco Systems OL-7396-01 Manual De Usuario

Descargar
Página de 934
7-8
ATM Switch Router Software Configuration Guide 
OL-7396-01
Chapter 7
Configuring Virtual Connections
Configuring Terminating PVC Connections
Configuring Terminating PVC Connections
This section describes configuring point-to-point and point-to-multipoint terminating permanent virtual 
channel (PVC) connections. Terminating connections provide the connection to the ATM switch router’s 
route processor for LAN emulation (LANE), IP over ATM, and control channels for Integrated Local 
Management Interface (ILMI), signalling, and Private Network-Network Interface (PNNI) plus network 
management.
 shows an example of transit and terminating connections.
Figure 7-2
Terminating PVC Types
Point-to-point and point-to-multipoint are two types of terminating connections. Both terminating 
connections are configured using the same commands as transit connections (discussed in the previous 
sections). However, all switch terminating connections use interface atm0 to connect to the route 
processor.
Note
Since release 12.0(1a)W5(5b) of the system software, addressing the interface on the processor (CPU) 
has changed. The ATM interface is now called atm0, and the Ethernet interface is now called ethernet0. 
The old formats (atm 2/0/0 and ethernet 2/0/0) are still supported.
UNI/NNI
12478
End system
Switch
Switch
fabric
CPU
ATM network
CPU
Point-to-multipoint connection
Point-to-point terminating connection
UNI/NNI
Switch
ATM network
UNI/NNI
UNI/NNI
Switch
fabric