Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Cisco Systems
  4. OL-7396-01
  5. Manual De Usuario

Cisco Systems OL-7396-01 Manual De Usuario

Descargar
Página de 934
7-13
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 7
Configuring Virtual Connections
Configuring PVP Connections
Deleting PVPs from an Interface
This section describes how to delete a PVP configured on an interface. To delete a PVP, perform the 
following steps, beginning in global configuration mode:
Example
The following example shows how to delete the PVP on ATM interface 1/1/0, VPI = 200:
Switch(config-if)# interface atm 1/1/0
Switch(config-if)# no atm pvp 200 
Confirming PVP Deletion
To confirm the deletion of a PVP from an interface, use the following EXEC command before and after 
deleting the PVP:
Example
The following example shows how to confirm that the PVP is deleted from the interface:
Switch# show atm vp
Interface         VPI  Type  X-InterfaceX-VPI     Status
ATM1/1/0          113  PVP    TUNNEL
ATM1/1/0          200  PVP    ATM1/1/1100 DOWN
ATM1/1/1          1    PVP    SHAPED TUNNEL
ATM1/1/1          100  PVP    ATM1/1/0200 DOWN
Switch# configure terminal
Switch(config)# interface atm 1/1/0
Switch(config-if)# no atm pvp 200
Switch(config-if)# end
Switch# show atm vp
Interface         VPI  Type  X-InterfaceX-VPI     Status
ATM1/1/0          113  PVP    TUNNEL
ATM1/1/1          1    PVP    SHAPED TUNNEL
Switch#
Command
Purpose
Step 1
Switch(config)# interface atm card/subcard/port
Switch(config-if)# 
Selects the interface to be configured.
Step 2
Switch(config-if)# no atm pvp vpi
Deletes the PVP.
Command
Purpose
show atm vp interface atm [card/subcard/port 
vpi]
Shows the PVCs configured on the interface.