Cisco Systems OL-7396-01 Manual De Usuario

This section describes configuring point-to-multipoint PVC connections. In 

, cells entering 

the ATM switch router at the root point (on the left side at interface ATM 0/0/0, VPI = 50, VCI = 100) 
are duplicated and switched to the leaf points (output interfaces) on the right side of the figure.

If desired, one of the leaf points can terminate in the ATM switch router at the route processor interface 
ATM 0.

To configure the point-to-multipoint PVC connections shown in 

, perform the following steps, 

beginning in global configuration mode:

To configure the point-to-multipoint PVC connections using the atm pvc command, the root point is 
port A and the leaf points are port B.

The row index for rx-cttr and tx-cttr must be configured before using this optional parameter. See 

H6297

UNI or NNI

ATM 

network

IF# = 0/1/1
VPI = 70, VCI = 210

IF# = 0/1/0
VPI = 60, VCI = 200

IF# = 0/0/0
VPI = 50, VCI = 100

IF# = 0/1/2
VPI = 80, VCI = 220

Switch

fabric

Switch(config)# interface atm 

card/subcard/port[.vpt#]

Switch(config-if)# 

Selects the interface to be configured.

Switch(config-if)# atm pvc vpi-A vci-A 

[cast-type type-A] [rx-cttr index] [tx-cttr index] 
[wrr-weight weight] [sched sched-A] interface 
atm card/subcard/port[.vpt#] vpi-B vci-B 
[cast-type type-B] [wrr-weight weight] [sched 
sched-B]

Configures the PVC between ATM switch router 
connections.