Cisco Systems OL-7396-01 Manual De Usuario

To configure the OSF, use the following global configuration command:

This value can be changed at any time, but it is only used at start-up and when a module is hot-swapped 
from the chassis.

The following example shows how to set the switch oversubscription factor to 16:

Switch(config)# atm over-subscription-factor 16

To display the OSF configuration, use the following EXEC command:

The following examples differ depending on the feature card installed in your switch.

The following example shows the switch OSF configuration with FC-PCQ installed:

Switch> show atm resource

Resource configuration:

 Over-subscription-factor 16  Sustained-cell-rate-margin-factor 1%

    Abr-mode:   relative-rate

    Atm service-category-limit (in cells):

         64544 cbr 64544 vbr-rt 64544 vbr-nrt 64544 abr-ubr

Resource state:

    Cells per service-category:

         0 cbr 0 vbr-rt 0 vbr-nrt 0 abr-ubr

The service category limit configuration restricts the number of cells admitted into the switch, as 
determined by the type of output queues.

Service category limit configuration is only possible on switches with FC-PCQ installed.

atm over-subscription-factor o-value

Configures the switch OSF from 1 to 32.

Displays the OSF configuration.