Cisco Systems OL-7396-01 Manual De Usuario

The following example shows the configuration of the interface link distance with switch processor 
feature card installed:

Switch> show atm interface resource atm 0/0/0

Resource Management configuration:

    Service Classes:

        Service Category map: c1 cbr, c2 vbr-rt, c3 vbr-nrt, c4 abr, c5 ubr

        Scheduling: RS c1 WRR c2, WRR c3, WRR c4, WRR c5

        WRR Weight: 8 c2, 1 c3, 1 c4, 1 c5

    Pacing: disabled   0 Kbps rate configured, 0 Kbps rate installed

    Service Categories supported: cbr,vbr-rt,vbr-nrt,abr,ubr

 Link Distance: 150 kilometers

    Controlled Link sharing:

        Max aggregate guaranteed services: none RX,  none TX

        Max bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,

                       none abr RX, none abr TX, none ubr RX, none ubr TX

        Min bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,

                       none abr RX, none abr TX, none ubr RX, none ubr TX

    Best effort connection limit: disabled  0 max connections

    Max traffic parameters by service (rate in Kbps, tolerance in cell-times):

        Peak-cell-rate RX: none cbr, none vbr, none abr, none ubr

        Peak-cell-rate TX: none cbr, none vbr, none abr, none ubr

        Sustained-cell-rate: none vbr RX, none vbr TX

        Minimum-cell-rate RX: none abr, none ubr

        Minimum-cell-rate TX: none abr, none ubr

        CDVT RX: none cbr, none vbr, none abr, none ubr

        CDVT TX: none cbr, none vbr, none abr, none ubr

        MBS: none vbr RX, none vbr TX

<information deleted>

Each interface can be configured to allow a specific number of best-effort available bit rate (ABR) and 
unspecified bit rate (UBR) connections. 

To configure the number of best-effort connections, perform the following tasks, beginning in global 
configuration mode:

These commands affect subsequent connections but not connections that are already established.

show atm interface resource atm 
card/subcard/port[.vpt#]

Displays the interface link distance 
configuration.

Switch(config)# interface atm 
card/subcard/port[.vpt#]

Switch(config-if)# 

Selects the interface to be configured.

Switch(config-if)# atm cac best-effort-limit 
conn-value

Configures the connection best-effort limit.