Cisco Systems OL-7396-01 Manual De Usuario
20-29
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 20
Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
Configuring Frame Relay to ATM Virtual Connections
Displaying Frame Relay to ATM Service Interworking PVCs
To display the service interworking PVC configuration, use the following EXEC commands:
Configuring Terminating Frame Relay to ATM Service Interworking PVCs
This section describes configuring terminating Frame Relay to ATM service interworking permanent
virtual channels (PVCs). This type of terminating connection provides the connection from IP over
Frame Relay to the ATM switch router used for IP over ATM and network management.
virtual channels (PVCs). This type of terminating connection provides the connection from IP over
Frame Relay to the ATM switch router used for IP over ATM and network management.
Figure 20-5 Frame Relay to ATM Transmit and Terminating Connections
Terminating connections are configured using the frame-relay pvc command; however, all switch
terminating connections use atm0 to connect to the ATM switch route processor.
terminating connections use atm0 to connect to the ATM switch route processor.
Command
Purpose
show interfaces [serial card/subcard/port:cgn] Shows the serial interface configuration.
show vc [interface {atm card/subcard/port
[vpi vci] | serial card/subcard/port:cgn [dlci]}]
[vpi vci] | serial card/subcard/port:cgn [dlci]}]
Shows the PVC interface configuration.
CPU
Switch
fabric
fabric
Frame Relay
UNI/NNI
ATM switch
Frame Relay
network
Frame Relay
end system
15884