Cisco Systems OL-7396-01 Manual De Usuario

To display the IMA group configuration, use the following EXEC commands:

The following example shows the IMA group interface configuration for IMA group 0/0/ima1 interface:

SwitchA# show ima interface atm 0/0/ima1

ATM0/0/ima1 is up

        Group Index    = 2

        State: NearEnd = operational, FarEnd = operational

        FailureStatus  = noFailure

IMA Group Current Configuration:

        MinNumTxLinks = 1    MinNumRxLinks = 1

        DiffDelayMax  = 25   FrameLength   = 128

        NeTxClkMode   = common(ctc)  CTC_Reference_Link = ATM0/0/3

        TestLink      = 3       Testpattern      = Not Specified

        TestProcStatus     = disabled   GTSM change timestamp = 990426154350

IMA Link Information:

Link           Physical Status        NearEnd Rx Status       Test Status

-----          ---------------        -----------------      ---------------

ATM0/0/2       up                     active                 disabled

ATM0/0/3       up                     active                 disabled

The following example shows the interface configuration for T1 IMA group 0/0/ima1:

SwitchA# show interfaces atm 0/0/ima1

ATM0/0/ima1 is up, line protocol is up

  Hardware is imapam_t1_ima

  MTU 4470 bytes, sub MTU 4470, BW 1500 Kbit, DLY 0 usec, rely 255/255, load 1/255

  Encapsulation ATM, loopback not set, keepalive not supported

  Last input 00:00:00, output 00:00:00, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/75/0 (size/max/drops); Total output drops: 0

  Queueing strategy: weighted fair

  Output queue: 0/1000/64/0 (size/max total/threshold/drops)

     Conversations  0/0/256 (active/max active/max total)

     Reserved Conversations 0/0 (allocated/max allocated)

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     223 packets input, 11819 bytes, 0 no buffer

     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

     215 packets output, 11395 bytes, 0 underruns

     0 output errors, 0 collisions, 1 interface resets

     0 output buffer failures, 0 output buffers swapped out

The following example shows the ATM layer interface configuration of the T1 IMA group 0/0/ima1:

SwitchA# show atm interface atm 0/0/ima1

Interface:      ATM0/0/ima1     Port-type:      imapam_t1_ima

IF Status:      UP              Admin Status:   up

show ima interface [atm card/subcard/imagroup 
[detailed]]

Displays IMA group interface configuration 
and status.

show interfaces atm card/subcard/imagroup

Displays IMA interface configuration and 
status.