Cisco Systems 1000 Series Manual De Usuario
16-39
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
High-Level Data Link Control-Ethernet Interworking
Note
Ethernet-to-EtherChannel over MPLS (Bridge) Interworking mode is also supported under VLAN.
High-Level Data Link Control-Ethernet Interworking
HDLC-Ethernet over MPLS is part of Any Transport over MPLS (AToM) solution. High-Level Link
Control (HDLC) and Ethernet are two link-layer transports that utilize the AToM architecture. This
section describes how these two transport types can communicate with each other using the AToM
framework.
Control (HDLC) and Ethernet are two link-layer transports that utilize the AToM architecture. This
section describes how these two transport types can communicate with each other using the AToM
framework.
shows the topology of the HDLC-Ethernet Interworking feature.
Figure 16-7
Topology of the HDLC-Ethernet Interworking Feature
The following features are supported from Cisco IOS XE Release 3.13.0S on the Cisco ASR 1000 Series
Aggregation Services Routers:
Aggregation Services Routers:
•
HDLC-Ethernet Bridged-Mode Interworking
•
HDLC-Ethernet Routed-Mode Interworking
•
HDLC Encapsulation: CISCO
•
Ethernet Encapsulation: Dot1Q, QinQ, Port Interface
Prerequisites for HDLC-Ethernet Interworking
Perform the following tasks to enable HDLC-Ethernet interworking:
•
Configure a controller slot on Ethernet CE:
controller E1 2/0
channel-group 0 timeslots 1
no shutdown
interface Serial2/0:0
no shutdown
•
Configure an Ethernet CE interface for Ethernet interworking:
bridge irb
Step 23
clock source internal
Specifies that the T1/E1 link uses the internal clock
from the interface.
from the interface.
Step 24
xconnect
peer-loopback vc-id pw-class pe-class-name
Binds an attachment circuit to a pseudowire to
configure an AToM static pseudowire, specifies
MPLS as the tunneling method, and enters xconnect
configuration mode.
configure an AToM static pseudowire, specifies
MPLS as the tunneling method, and enters xconnect
configuration mode.
Command or Action
Purpose
HDLC CE
Ethernet CE
Ethernet
MPLS
HDLC
PE
PE
391635