Cisco Systems 1000 Series Manual De Usuario
18-65
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 18 LSM-MLDP-based MVPN Support
MVPN MLDP over GRE
32.
end
DETAILED STEPS
Command
Purpose
Step 1
enable
Example:
Router> enable
Enables the privileged EXEC mode. Enter your password
when prompted.
when prompted.
Step 2
configure
terminal
Example:
Router# configure terminal
Enters the global configuration mode.
Step 3
mpls MLDP
Example:
Router(config)# mpls MLDP
Enables MPLS MLDP support.
Note
The mpls MLDP command is configured by
default. To disable MPLS MLDP, use the no mpls
MLDP command.
default. To disable MPLS MLDP, use the no mpls
MLDP command.
Step 4
vrf definition
vrf-name
Example:
Router(config)# vrf definition blue
Defines the VPN routing instance by assigning a VRF
name, and enters the VRF configuration mode.
name, and enters the VRF configuration mode.
vrf-name—Name assigned to a VRF.
Step 5
rd
route-distinguisher
Example:
Router(config-vrf)# rd 200:2
Creates routing and forwarding tables.
route-distinguisher— Specifies the 8-byte value to create
a VPN prefix.
a VPN prefix.
You can enter a route-distinguisher value in either of
these formats:
these formats:
•
16-bit autonomous system number: Your 16-bit
number Example, 200:2.
number Example, 200:2.
•
32-bit IP address: Your 32-bit number Example,
192.168.122.15:1.
192.168.122.15:1.
Step 6
vpn id
vpn-id
Example:
Router(config-vrf)# vpn id 200:2
Sets or updates a VPN identifier on a VRF.
Step 7
address-family ipv4
Example:
Router(config-vrf)# address-family ipv4
Enters the address family configuration mode using
standard IP Version 4 (IPv4) address prefixes.
standard IP Version 4 (IPv4) address prefixes.