Cisco Systems 9000 Manual De Usuario

You need the following tool to perform this task: 

7/16 hex socket and torque wrench, torque 50 in-lb.

Follow these steps to reinstall the DC power modules back into the chassis (see 

 for the 

version 1 power module or 

 for the version 2 or version 3 power module.

Slide the power module into the power tray until it mates with its backplane connector.

Secure the module.

Version 1 power module: Pivot the power module door fully to the left until it locks to securely seat 
the power module to its backplane connector.

Version 2 power and version 3 module: Move the handle up and tighten the screw using the 7/16 hex 
socket and torque wrench with the torque set to 50 in-lb.

To prevent damage to the power tray backplane connector, do not use excessive force when inserting the 
power module into the power tray.

Repeat 

 and 

 for the other DC power modules.

Install the power modules before installing the fan trays.

You need the following tool to perform this task: 

6-inch long number 2 Phillips screwdriver, torque 10 inch-lb.

If you are installing a fan tray for the Cisco ASR 9010 Router, install the lower fan tray before attaching 
the accessory grill. The lower fan tray slot is located behind the accessory grill. See the