Cisco Systems 9000 Manual De Usuario

This section describes how to route the network interface cables through the router cable-management 
system and attach the network interface cables to the line card ports.

This procedure uses an 40x1GE line card as an example to describe how to attach a network interface 
cable to a line card port and route the cable through the cable-management system. Depending on which 
line cards are installed in your system, your cable connection procedure might differ slightly from this 
example. For cable connection information for your specific line card, refer to the installation and 
configuration note for that line card.

You can access the most current Cisco line card documentation online at: 

Follow these steps as an example to route the network interface cables through the cable-management 
system and connect them to the line card:

Route an interface cable across the horizontal cable management tray (

), and down through 

the cable tray opening to connect it to the line card.

Each line card has its own cable routing slot in the cable management tray. For example, 

 

shows cables being routed to line card 3 in slot 3 in a Cisco ASR 9010 Router.

Attach a line card cable management bracket to the line card front panel (

). This bracket is 

shipped with the line card.

1  Hinged cover (shown in the raised position)

2 Line card cable bundle routed through the tray

243259