Cisco Systems 9000 Manual De Usuario

Confirm your choice.

Please confirm that you wish to upgrade from AC power supply version 2 power system to DC 

power supply version 2 power system by typing "yes" at the prompt below. Any other 

response will cancel the power system change operation [yes/cancel]?

After the success message appears, power down the chassis.

start update CBC eeprom, offset = 0x0,length=1000

  ..............................................................

  done update CBC eeprom

  start update I2C eeprom

  ...............................................................

  done update I2C eeprom

The power system programming change is complete. The system must now be completely powered 

down, and the NEW power system hardware installed. When the system is rebooted the 

software will recognize the new power system. Please power down the system at this point.

#

Remove the old power module (see 

 or 

Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).

Install the new power module (see 

).

To prevent damage to the power tray backplane connector, do not use excessive force when inserting the 
power module into the power tray.

Power up the chassis.

Verify that the (green) Power Input indicator on the front of the power module goes on. If the indicator 
does not light, see 

.

Follow these steps to remove a version 1 AC or DC power module from the power tray (

). 

Push the door latch to the left to release the door.

Pivot the door to the right to eject the power module from its bay.

Slide the power module out of its bay while supporting it with your other hand.

Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).