Cisco Systems ONS 15600 Manual De Usuario

This chapter explains how to change transmission settings on cards in a Cisco ONS 15600. 

As necessary, complete the 

. 

Before performing the following procedures, investigate all alarms and clear any trouble conditions. 
Refer to the Cisco ONS 15600 Troubleshooting Guide as necessary.

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).

—Complete this procedure to provision a multirate 

pluggable port module (PPM), for the ASAP card. If a multirate PPM was preprovisioned, this 
procedure is unnecessary.

—Complete this procedure to provision the 

optical line rate on a multirate PPM for the ASAP card. Single-rate PPMs do not need to be 
provisioned.

—As needed, complete this procedure to edit 

optical line rates for multirate PPMs on the ASAP card.

—As needed, complete this procedure to 

delete PPMs for the ASAP card.

—As needed, complete 

this procedure to change line (drop) and threshold settings for all OC-N cards. 

—As needed, complete this procedure to 

change an optical port from SONET to SDH.

—As needed, complete this procedure to change 

card service state.