Cisco Systems ONS 15600 Manual De Usuario

Complete the 

 to log into an ONS 15600 on the network.

Click the Alarms tab:

Verify that the alarm filter is not turned on. See the 

 as necessary.

Verify that no unexplained conditions appear on the network. If unexplained conditions appear, 
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.

Complete the 

 to export alarm and condition 

information.

In node view, double-click the ASAP card where you want to provision the line rate. 

Click the Provisioning > Pluggable Port Modules tabs. 

In the Pluggable Ports pane, click Create. The Create Port dialog box appears.

In the Create Port dialog box, complete the following:

Port—Click the PPM number and port number from the drop-down list. The first number indicates 
the PPM and the second number indicates the port number on the PPM. For example, the first PPM 
with one port displays as 1-1 and the second PPM with one port displays as 2-1. When a 4PIO is 
present on an ASAP card, the port is identified as 4PIO#-PPM#-Port# (for example 4-4-1). The 4PIO 
number can be 1 to 4, the PPM number can be 1 to 4, but the port number is always 1. 

Port Type—Click the type of port from the drop-down list. The port type menu displays the 
supported port rates on your PPM. See 

 for definitions of the supported rates on the ASAP 

card. 

Click OK.

Repeat Steps 

 through 

 to configure the port rates as needed.

This procedure provisions the line rate on a multirate pluggable port 
module (PPM). Single-rate small-form factor pluggables (SFPs) or 4-port 
I/O modules (4PIOs) do not need line rate provisioning. 

None

Required

Onsite or remote

Provisioning or higher

ASAP

OC-3—155 Mbps

OC-12—622 Mbps

OC-48—2.48 Gbps

ETHER—10 Gbps Ethernet