Cisco Systems A9KMOD80TR Manual De Usuario
F I N A L D R A F T — C i s c o C o n f i d e n t i a l
5-10
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-17502-01
Chapter 5 CLI Tips, Techniques, and Shortcuts
Viewing System Information with show Commands
Gi0/2/0/0 is administratively down, line protocol is administratively down
0 drops for unrecognized upper-level protocol
Gi0/2/0/1 is administratively down, line protocol is administratively down
0 drops for unrecognized upper-level protocol
Gi0/2/0/2 is administratively down, line protocol is administratively down
0 drops for unrecognized upper-level protocol
Gi0/2/0/3 is administratively down, line protocol is administratively down
0 drops for unrecognized upper-level protocol
MgmtEthernet0/RSP0/CPU0/0 is administratively down, line protocol is administratively
down
MgmtEthernet0/RSP0/CPU0/0 is administratively down, line protocol is administratively
down
0 drops for unrecognized upper-level protocol
Note
Filtering is available for submodes, complete commands, and anywhere that
<cr>
appears in the “?”
output.
Adding a Filter at the --More-- Prompt
You can specify a filter at the
--More--
prompt of a show command output by entering a forward slash
(/) followed by a regular expression. The filter remains active until the command output finishes or is
interrupted (using Ctrl-Z or Ctrl-C). The following rules apply to this technique:
interrupted (using Ctrl-Z or Ctrl-C). The following rules apply to this technique:
•
If a filter is specified at the original command or previous
--More--
prompt, a second filter cannot
be applied.
•
The use of the keyword begin does not constitute a filter.
•
The minus sign (–) preceding a regular expression displays output lines that do not contain the
regular expression.
regular expression.
•
The plus sign (+) preceding a regular expression displays output lines that contain the regular
expression.
expression.
In the following example, the user adds a filter at the
--More--
prompt to show only the lines in the
remaining output that contain the regular expression “ip.”
RP/0/RSP0/CPU0:router# show configuration running | begin line
Building configuration...
line console
exec-timeout 120 120
!
logging trap
--More--
/ip
filtering...
ip route 0.0.0.0 255.255.0.0 Gi0/2/0/0
interface Gi0/2/0/0
ip address 172.19.73.215 255.255.0.0
end
Tip
On most systems, Ctrl-Z can be entered at any time to interrupt the output and return to EXEC mode.
For more information, see