Lucent Technologies 7820-0657-001 Manual De Usuario
Connecting the cables
2-4
DSLPipe DSU (SDSL) User’s Guide
Table 2-2 shows the proper setting for each configuration
.
Connecting the cables
To connect your DSLPipe DSU:
1
Use the V.35 to DB-25 cable to connect the V.35 device to the DSLPipe
DSU.
DSU.
2
Use the WAN cable to connect the DSLPipe DSU to the SDSL line.
3
Use the power supply cable to connect the DSLPipe DSU to a power source.
Plugging the power supply automatically turns on the DSLPipe DSU.
Plugging the power supply automatically turns on the DSLPipe DSU.
Checking the activity of the LED lights
To verify that your DSLPipe DSU is connected properly, observe the activity
pattern of the lights at the front of the unit (see Figure ). When all the cables are
connected, verify that:
pattern of the lights at the front of the unit (see Figure ). When all the cables are
connected, verify that:
•
The
con
light is on initially and then turns off. It blinks if there are any
SDSL errors.
•
The
wan
light turns on after the
con
light turns off. It blinks until a
connection is established, and then remains on.
•
The
lnk
light is on if the DSR (Data Set Ready) or the RTS (Request To
Send) control on the V.35 port is active.
•
The
act
light blinks when there is any DSL activity, but it remains off
otherwise.
•
The
pwr
light comes on and remains on.
Table 2-2. CPE vs. COE configuration
Configuration
DIP Switch 4
CPE
OFF
COE
ON