Schneider Electric 61 Manual De Usuario

 

104

Parameter name:

Logic address:

7130 = 16#1BDA

Type:

WORD (bit register)

CANopen index:

2029/1F

Read/write:

R

INTERBUS index:

5FB6/1A

Unit:

-

DeviceNet path:

84/01/83

bit 0: = 1: Change of rating
bit 1: Reserved (= 0 or 1)
bit 2: = 1: The network card has been removed
bit 3: = 1: Saving to the EEPROM non-volatile memory is inconsistent with power on

bit 4: = 1: The network card has been changed
bit 5: Reserved (= 0 or 1)
bit 6: = 1: The (Controller Inside) card has been removed
bit 7: = 1: The (Controller Inside) card has been changed

bit 8: Reserved (= 0 or 1)
bit 9: = 1: An I/O card has been removed

bit 10: = 1: The I/O card has been changed
bit 11: Reserved (= 0 or 1)

bit 12: = 1: An encoder card has been removed
bit 13: = 1: The encoder card has been changed
bit 14: Reserved (= 0 or 1)
bit 15: Reserved (= 0 or 1)

If one of these events occurs, the drive switches to 

(CFF)

 fault mode and then automatically applies a 

factory setting.

Parameter name:

Logic address:

7133 = 16#1BDD

Type:

UINT

CANopen index:

2029/22

Read/write:

R

INTERBUS index:

5FB0/99

Unit:

1

DeviceNet path:

84/01/86

The fault remains saved in the parameter, even if it disappears.
The parameter is reset after the drive is disconnected and then reconnected.

Consult the "Controller Inside" card manual.

Parameter name:

Logic address:

7132 = 16#1BDC

Type:

UINT

CANopen index:

2029/21

Read/write:

R

INTERBUS index:

5FB0/98

Unit:

1

DeviceNet path:

84/01/85

The fault remains saved in the parameter, even if it disappears.
The parameter is reset after the drive is disconnected and then reconnected.

The possible values of this parameter depend on the network card protocol. Consult the manual for the corresponding card.