RAD Data comm E1/T1 Manual De Usuario
Chapter 2 Installation and Setup
FCD-IPM Installation and Operation Manual
2-2
Installation and Setup
2.2 Package Contents
Inspect the equipment package before unpacking. Note and report damage
immediately. The FCD-IPM package includes the following items:
• FCD-IPM unit
• Multiservice Access Devices and Intelligent CLEs CD
• CBL-RJ45/D9/F/6FT configuration cable
• Interface adapter cable in accordance with your order
• AC power cable or DC power connection kit.
immediately. The FCD-IPM package includes the following items:
• FCD-IPM unit
• Multiservice Access Devices and Intelligent CLEs CD
• CBL-RJ45/D9/F/6FT configuration cable
• Interface adapter cable in accordance with your order
• AC power cable or DC power connection kit.
2.3 Equipment Needed
The cables you need depend on the application. Cables terminated in appropriate
connectors provide support for the following data port interfaces:
• V.35 interface: the interface adapter cable ends in a 34-pin female connector
• V.36/422 interface: the interface adapter cable ends in a 37-pin D-type
connectors provide support for the following data port interfaces:
• V.35 interface: the interface adapter cable ends in a 34-pin female connector
• V.36/422 interface: the interface adapter cable ends in a 37-pin D-type
female connector
• V.24/RS-232 or RS-530 interface: the interface adapter cable ends in a 25-pin
D-type female connector
• X.21 interface: the interface adapter cable ends in a 15 pin D-type female
connector.
2.4 Installation and Setup
The FCD-IPM units are delivered completely assembled. The units are designed
for desktop installation.
For installation of FCD-IPM in a 19-inch rack, the RM-34 rack mount kit is
available. For rack installation instructions, refer to the
For installation of FCD-IPM in a 19-inch rack, the RM-34 rack mount kit is
available. For rack installation instructions, refer to the
Rack Mounting Kit for
19-inch Racks
guide that comes with the RM kit.
Installation procedures for FCD-IPM are provided in the following paragraphs.
Setting Internal Jumpers and Switches
Only the BAL/UNBAL jumpers, whose locations are shown in
are
meant for user adjustment. All other internal jumpers are factory set according to
the specific ordering requirements and are not designed for user access. The
factory setting for the BAL/UNBAL jumpers is BAL. Before setting these jumpers,
open the FCD-IPM case.
the specific ordering requirements and are not designed for user access. The
factory setting for the BAL/UNBAL jumpers is BAL. Before setting these jumpers,
open the FCD-IPM case.