Schneider Electric TSXETG100 Manual De Usuario

™ Ethernet Gateway

© 2006 Schneider Electric. All Rights Reserved.

The ETG supports SNMP, allowing a network administrator to remotely 
access an ETG with an SNMP manager and view the networking status and 
diagnostics in the MIB2 format.

1. From the Setup page, click SNMP 

Parameters.

Opens the SNMP Parameters page.

2. Check Enable SNMP to turn ON the simple 

network management protocol.

NOTE: If you uncheck Enable SNMP and 
click Apply, the ETG will reboot and SNMP 
functionality will be turned OFF.

Activates SNMP.

3. Enter the system contact, system name, 

system location, read-only community 
name, and the read-write community name.

Enters the SNMP system information and 
community access names.

4. Click Apply.

Saves the SNMP settings.