Black Box ET10000A Manual De Usuario

12

EncrypTight Manager Installation Guide

•

Modify the /opt/scripts/policyserver-init.conf and set the following. Emacs, nano, and vi are available 
on the OS.

########################################################################
#######
#######
####### Cluster options
#######
#
## for

 

a clustered installation node1 and node2 must be set the same 

## on each of the hosts in the cluster, same ordering
node1=192.168.80.1
node2=192.168.80.2
#
# clusterJdbcMcast=229.10.10.10
# clusterMcast=228.10.10.10
# clusterName=policyserver
#

###############################################################################

Run the installation script:

/etc/init.d/policyserver-install

It is important that the ordering of IP addresses stays the same for node1 and node2 on both machines in 
the cluster.

You should install in the following steps:

1 Deploy OVA app server #1 (See Appendices - EncrypTight Manager OVA Deployment Using 

vSphere Client)

2 Deploy OVA app server #2 (See Appendices - EncrypTight Manager OVA Deployment Using 

vSphere Client)

3 Assign IP of app server #1
4 Assign IP of app server #2
5 Run cluster install on app server #1 ( same order of IP addresses on both )
6 IMPORTANT: WAIT for app server #1 to fully start
7 Run cluster install on app server #2 ( same order of IP addresses on both )

Once installation is complete you can view the web interface from either of the cluster nodes IP 
addresses.

To verify that the cluster is in place check the Platform -> Utilities page DB Nodes and Appserver Nodes.

If you are going to have the cluster on node1 = 192.168.80.1 and node2 = 192.168.80.2 then you would 
run like this on both installs:

Modify the /opt/scripts/policyserver-init.conf and set the following. Emacs, nano, and vi are available on 
the OS.