Bay Technical Associates none Manual De Usuario
Installing and Operating BayStack ARN Routers
1-26
114200 Rev. A
Connecting to a V.34 Modem Module
If your ARN contains an optional, back-panel V.34 modem module, you need only
connect the telephone line to the V.34 interface for access to the router.
connect the telephone line to the V.34 interface for access to the router.
provides the default settings for the back-panel V.34 modem adapter.
Note:
The default settings for the back-panel V.34 modem differ from the
default settings for the front-panel V.34 modem adapter module. Refer to
“Connecting to a V.34 Modem Interface” earlier in this chapter for information
about the V.34 modem adapter and its default settings.
“Connecting to a V.34 Modem Interface” earlier in this chapter for information
about the V.34 modem adapter and its default settings.
Table 1-5.
Back-Panel V.34 Modem Defaults
Modem Signal/Parameter
Value
Clear To Send (CTS)
On
Data Terminal Ready (DTR)
Set to answer all incoming calls.
Data Carrier Detect (DCD) or RLSD On while carrier is present (the ARN uses DCD to
detect modem connect and disconnect).
Data Set Ready (DSR)
On
Ready to Send (RTS)
Ignored
Synchronous/Asynchronous Mode
Asynchronous
AutoAnswer
Answer on 2 rings with DTR active.
Local Character Echo
Off
Supervisory Functions
Off
Baud Rate
9600
Data Bits
8
Stop Bits
1
Parity
None
Note:
Physically connecting to either a front-panel or back-panel V.34 modem
interface is essentially the same. Refer to “Connecting to a V.34 Modem
Interface” earlier in this chapter for details.
Interface” earlier in this chapter for details.